Service
Prewire
Prewire is the one part of home technology you cannot add cheaply later. Done right, it is invisible, labeled and ready for equipment that has not been invented yet.
Overview
We run and terminate cabling for network, speakers, video, control, cameras and access points to the locations in the design. Every run is labeled at both ends and recorded, and we walk the site with the builder before insulation and drywall.
Extra conduit and spare pulls are planned where a future upgrade is likely, such as a theater, an outdoor kitchen or a wall that will hold a large display.
- Cat6 / Cat6A network cabling
- Speaker and subwoofer cabling
- HDMI and video conduits
- Camera and access-point pulls
- Keypad and control wiring
- Labeled as-built documentation
- Pre-drywall walkthrough
What a typical project looks like
1. Consultation
We talk through the home, the rooms, your priorities and a budget range.
2. Design
Systems, locations and wiring are planned on paper, ideally before construction.
3. Install
Wiring goes in at the right stage, then equipment is installed and programmed.
4. Handoff
We walk you through the system and stay available for questions and support.
Frequently asked questions
Can prewire be done on a remodel?
Yes, where walls are open or accessible. In finished homes we look at attics, crawlspaces and chases first; some rooms may need wireless or surface solutions.
What if the electrician or builder already ran some wire?
We review what is in place, keep what is usable, and document what was added so the plan stays accurate.
Areas we serve
We install prewire for homes across northern Utah.
Talk to us about Prewire
A short conversation is enough to outline scope, timing and budget ranges.